P2 · Trust / Certification
HACCP and ISO 22000 Certified Camellia Oil
Every shipment leaves with a batch-specific certificate of analysis, and every batch carries one code from seed intake to drum. Five certificates are current — but three of them cover sales only, which the table below states rather than hides.
What is tested, and who tests it
Two different tests sit behind this page. The oil itself is tested by Centre Testing International, a third-party laboratory, against GB/T 11765-2018 and the contaminant standards. Each production batch is then tested in-house and a certificate of analysis is issued with the shipment. The third-party report is published; the batch COA travels with your order.
| Test | Who runs it | What it covers | When |
|---|---|---|---|
| Third-party analysis | Centre Testing International (CTI) | 28 parameters: physical and chemical, fatty acids, contaminants | Report No. A2240440191101001C, issued 30 July 2024 |
| Batch certificate of analysis | Issued per production batch | Batch values against the same standards | With each shipment |
| Incoming seed check | In-house, at intake | Appearance and moisture | Every seed lot received |
The five certificates, with scope and expiry
Five management-system certificates are current. Two cover production and sales together; three cover sales scope only, which is what the certificate itself states. Read the scope column before the logo — a certificate held for sales does not certify the plant floor.
| Certificate | Number | Scope | Valid until |
|---|---|---|---|
| HACCP | 007HACCP2400208 | Production and sales | 2027-12-22 |
| ISO 22000 | 007FSMS2400279 | Production and sales | 2027-12-22 |
| ISO 9001 | 18524Q11747R0S | Sales scope only | 2027-11-27 |
| ISO 14001 | 18524E11085R0S | Sales scope only | 2027-11-27 |
| ISO 45001 | 18524S11028R0S | Sales scope only | 2027-11-27 |
How to verify each number
Every certificate above can be checked independently — we would rather you did. HACCP and ISO 22000 were issued by Zhongjian Certification; the three ISO certificates by Zhongbiao Lianhe (Beijing). Copy any number into the CNCA national certification register at cx.cnca.cn, or search the issuing body’s own portal.
A scan of a certificate proves nothing on its own. The register does.
National programme participation
In 2024 we were appointed an implementing enterprise for the "Quality Grain and Oil Programme — upgraded edition" demonstration county project, a national programme run under China’s grain and oil quality framework. The appointment covers the plant in Qiyang, and it is a programme role rather than a certification.
Where quality is controlled on the line
Quality is checked at three points rather than at the end: seed intake, before pressing, and during pressing and filtration. Each point has a written standard and a record, so a problem is caught where it happens instead of being discovered in the customer’s warehouse.
| Stage | Control point | What is checked |
|---|---|---|
| 1. Seed intake | Reception | Appearance and moisture; lot code assigned |
| 2. Before pressing | Drying and dehulling | Moisture at 6–9 %; kernel/husk separation |
| 3. Pressing and filtration | Twin-screw press, leaf filter | Pressing temperature at or below 60 °C; filtration pressure |
Traceability: one batch code, from grove to drum
Each batch carries a single code from seed intake through pressing, filtration and packing. With that code we can pull the seed lot, the pressing date, the filtration record and the packing record. If you need to trace a drum back to the week it was pressed, the code on the drum is enough.
What you receive with each shipment
Four documents go out with every order: the batch certificate of analysis, the packing list, the certificate of origin and the bill of lading. The full third-party report is available on request. We do not publish report scans, because the laboratory’s terms do not allow partial reproduction.
| Document | With every shipment | On request |
|---|---|---|
| Batch certificate of analysis | ✓ | — |
| Packing list | ✓ | — |
| Certificate of origin | ✓ | — |
| Bill of lading | ✓ | — |
| Full CTI report | — | ✓ |
| Certificates (copies) | — | ✓ |
What happens when a batch does not meet specification
A batch that fails a check is neither packed nor shipped. If a delivered batch misses the agreed specification, it can be returned and we re-test it. Because we grow the seed, press the oil and pack it ourselves, there is no upstream supplier to pass a complaint to — that batch stays our problem until resolved.
Frequently asked questions
Six questions come up in almost every quality enquiry: who does the testing, whether certificates cover production, what comes with a shipment, how traceability works, what happens to a failed batch and whether the plant is audited. Short answers follow.
Who tests the oil?
Centre Testing International, a third-party laboratory, for the published analysis. Each production batch is also tested in-house before packing.
Do your certificates cover production?
Two do — HACCP and ISO 22000 cover production and sales. ISO 9001, ISO 14001 and ISO 45001 are held for sales scope only, as stated on the certificates.
Can I see the full test report?
Yes, on request. You can also verify it yourself: enter report number A2240440191101001C and code SEF9 at mycti.cti-cert.com.
How do I trace a drum back to its batch?
Every drum carries a batch code. With that code we can retrieve the seed lot, pressing date and packing record.
What happens if a batch fails?
A batch that fails a check is not packed and not shipped. If a delivered batch misses the agreed specification, it can be returned and we re-test it. It is never blended into a passing batch.
Is the plant audited by your customers?
Yes. Customer audits and plant visits are arranged on request, in Qiyang, Hunan. We ask for two weeks’ notice so the line is running on the day you come.